
Configuring PPP Services
1-4 117360-A Rev. A
Starting PPP
Services
When you add a PPP circuit, it is automatically enabled. To let data flow over this
interface, you must also enable an upper-layer routing protocol (such as IP, IPX,
or AppleTalk) to run on top of PPP. See the appropriate protocol-specific guides
for information on these upper-layer protocols.
Using the BCC
To enable IP routing on a given interface, navigate to the IP prompt and enter
state enable
For example, the following command enables IP routing on the interface with the
IP address of 1.1.1.1.
ip/1.1.1.1# state enable
Using Site Manager
To enable IP routing over this PPP interface, do the tasks in the following table.
Note: BCC supports only IP as the upper-layer protocol.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Set IP Enable to Enable. (See
page A-3.)
4. Click on OK to accept the default values
for all other PPP parameters.
The Configuration Manager window
appears.
Comentarios a estos manuales