
Configuring PPP Services
A-4 117360-A Rev. A
Parameter: XNS Enable
Path: Protocols > PPP > Interfaces
Default: If you enable XNS support when you configure PPP on this interface, this
parameter is automatically set to Enable. Otherwise, the default is Disable.
Options: Enable
| Disable
Function: Enables or disables the network control protocol for XNS.
This parameter does not enable or disable XNS routing services for the
interface; it affects the network control protocol for XNS. However, disabling
the network control protocol for XNS stops XNS traffic from being routed over
this interface.
Instructions: To stop XNS traffic from being routed over this interface, set this parameter to
Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.14
Parameter: DECnet IV Enable
Path: Protocols > PPP > Interfaces
Default: If you enable DECnet IV support when you configure PPP on this interface, this
parameter is automatically set to Enable. Otherwise, the default is Disable.
Options: Enable
| Disable
Function: Enables or disables the network control protocol for DECnet IV.
This parameter does not enable or disable DECnet IV routing services for the
interface; it affects the network control protocol for DECnet IV. However,
disabling the network control protocol for DECnet IV stops DECnet IV traffic
from being routed over this interface.
Instructions: To stop DECnet IV traffic from being routed over this interface, set this
parameter to Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.15
Comentarios a estos manuales