
PPP Parameters
117360-A Rev. A A-25
Parameter: CHAP Periodic Timer
Path: Protocols > PPP > Interfaces > Lines
Default: 0 (disabled)
Options: Any number of seconds. Setting this value to 0 disables the timer. A reasonable
value for this parameter is 60.
Function: Allows for repeated authentication challenges at an interval (in seconds) that
either peer on the link can specify. The timer begins counting when an
authentication phase has completed. A new challenge does not begin until the
amount of time you specify elapses.
Instructions: Accept the default or set this parameter to 60.
If you have not configured CHAP, ignore this field.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.1.1.35
Parameter: Allow PAP Reject
Path: Protocols > PPP > Interfaces > Lines
Default: Disable
Options: Enable
| Disable
Function: Some peers do not use PAP. If you set this parameter to Enable, your router
accepts the reject message from such a peer and removes PAP from the LCP
configure-request.
Instructions: Select Enable or Disable.
If you have not configured PAP, ignore this field.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.1.1.39
Comentarios a estos manuales