
Starting PPP Services
117360-A Rev. A 1-5
Disabling and Reenabling PPP Services
After changing certain PPP line parameters, you must force renegotiation of the
link. To do this, you first disable, then reenable PPP on the link. Disabling the link
also stops the flow of traffic from routing over the PPP interface, even though the
upper-layer protocol may still be enabled.
Using the BCC
In BCC configuration mode, navigate to the PPP prompt for the interface and
enter
state disable
Then reenable PPP on the interface by entering
state enable
For example, the following commands force renegotiation of the link by
disabling, then reenabling PPP routing on the interface slot 3, circuit 1.
ppp/3/1# state disable
ppp/3/1# state enable
Using Site Manager
To force link renegotiation for this PPP interface, do the tasks in the following
table.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Choose Lines. The Lines window opens.
4. Set Enable (LCP) to Disable.
(See page A-14)
5. Click on OK. The Interfaces window opens.
6. Set Enable (LCP) to Enable. (See
page A-14.)
7. Click on OK. The Interfaces window appears.
Comentarios a estos manuales