
Configuring PPP Services
A-12 117360-A Rev. A
Parameter: PPP Mode
Path: Protocols > PPP > Interfaces
Default: Multilink for a dial-on-demand or bandwidth-on-demand circuit
Normal for a nonmultilink circuit
Options: Normal for a nonmultilink circuit
Multilink
| Monitor for a dial-on-demand or bandwidth-on-demand circuit
Normal
| Multilink for all other circuit types
Function: Specifies the type of multiline or multilink connection on this interface.
Instructions: The set of available options depends on the type of circuit you’re configuring.
Select one of the following values:
Normal - to configure a nonmultilink circuit
Multilink - to enable the multilink feature
Monitor - to designate the local router as the multilink monitor
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.50
Parameter: Multilink Fragmentation
Path: Protocols > PPP > Interfaces
Default: Permitted
Options: Permitted
| Prohibited
Function: This parameter is active only for multilink. Allows packet fragmentation on
multilink circuits, when needed.
Instructions: Accept the default, Permitted, if you want to allow multilink packet
fragmentation. Otherwise, specify Prohibited.
MIB Object ID: 1.3.6.1.4.1.18.3.5.9.2.2.1.51
Comentarios a estos manuales