
Customizing PPP
117360-A Rev. A 3-23
Specifying the Maximum Configuration Failure Count
The Max Configuration Failure Count parameter specifies the maximum number
of configure-NAK packets that the router sends before sending a configure-reject
packet for those options that it does not agree with. The default value is 10
packets.
Using the BCC
Navigate to the line prompt for the interface and enter
max-configure-fails
seconds
For example, the following command sets the maximum number of
configure-NAK packets allowed to 5 on interface 3/1.
line/3/1# max-configure-fails 5
4. Set Max Terminate-Requests.
(See page A-16.)
5. If you have no other PPP line parameters
to configure, click on OK. Otherwise,
continue with the Lines configuration.
The Interfaces window opens.
Site Manager Procedure
(continued)
You do this System responds
Comentarios a estos manuales