
Customizing PPP
117360-A Rev. A 3-3
Enabling PPP on an Interface
If you have already enabled PPP on the circuit that you want to configure, go to
“Setting Up Remote
Addresses” on Chapter 3-4. If you haven’t already done so,
you must enable PPP on the interface. To do this, refer to Chapter 1.
By default, the protocol that you selected when you first configured this interface
is enabled. If you want to enable a different protocol, you can do so as part of the
customization. BCC supports only IP.
Using the BCC
To enable IP routing on a given interface, navigate to the IP prompt and enter
state enable
For example, the following command enables IP routing on the interface with the
IP address of 1.1.1.1.
ip/1.1.1.1# state enable
Using Site Manager
To enable IP routing over this PPP interface, do the tasks in the following table.
The rest of this chapter describes how to configure and customize PPP for your
system. Follow the instructions that apply to your network requirements.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Set IP Enable to Enable. (See page A-3.)
4. If you have no other Interface parameters
to configure, click on OK. Otherwise,
continue with the Interface configuration.
The Configuration Manager window
appears.
Comentarios a estos manuales