
Site Manager Parameters
117355-D Rev 00
A-53
Parameter: Join/Prune Interval
Path: Configuration Manager > Protocols > IP > PIM > Interface
Default: 60
Options: 1 to 65,535 seconds
Function: Specifies the time period, in seconds, at which the PIM router sends periodic
join/prune messages on this PIM interface. This interval takes effect only if you
disabled the Use Global Join/Prune Interval parameter.
Instructions: Determine the join/prune interval that you require and specify a value from 1
through 65,535 seconds (18 hours, 12 minutes, and 15 seconds).
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.14.2.1.11
Parameter: Downstream IGMP Relay
Path: Configuration Manager > Protocols > IP > PIM > Interface
Default: Disable
Options: Enable
|
Disable
Function: Indicates whether you want to enable or disable support for IGMP Relay on a
downstream router.
Instructions: Set to Enable to allow the PIM router to receive multicast data from a
downstream router configured with IGMP Relay, encapsulate the data within a
register packet, and send the packet to the elected RP in the PIM domain.
If you enable this parameter on a PIM interface, you must configure all other
PIM routers on the same physical link to enable this parameter on the same PIM
interface.
If you set this parameter to Disable, the PIM router drops multicast packets
forwarded from the IGMP Relay router.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.14.2.1.12
Comentarios a estos manuales