
Configuring IP Multicasting and Multimedia Services
4-74
117355-D Rev 00
Configuring DVMRP Accept Policies
A DVMRP accept policy applies to incoming advertisements. To configure a
DVMRP accept policy, you can use either the BCC or Site Manager.
Using the BCC
To create a DVMRP accept policy, navigate to the global DVMRP prompt (for
example,
box; ip; dvmrp
) and enter:
accept
<polname>
<polname>
is the name of the DVMRP accept policy.
For example, the following command creates a DVMRP accept policy called
“dvmrppol3”:
dvmrp#
accept dvmrppol3
accept/dvmrppol3/dvmrp#
To customize a DVMRP accept policy, set one or more of the following
parameters (Table 4-5
):
Table 4-5. DVMRP Accept Policy BCC Parameters
Parameter Values (default = d) Description
action accept (d)
|
ignore Specifies whether to accept or ignore the interfaces or networks
for a route that matches this policy.
• To import the matching route from the IP routing table to the
DVMRP routing table, use accept.
• If you do not want to import the matching route, use ignore.
gateway
list of IP addresses
|
null (d)
Specifies the addresses of one or more routers that can send
DVMRP updates to this router. If you configure a list, this policy
applies to DVMRP advertisements from the routers in the list.
To apply this policy to any router, use the default, null.
inject null (d)
|
list of IP addresses
and masks
Specifies an IP network that DVMRP injects into the DVMRP
routing table in place of the advertised networks. This parameter
has meaning only if the action is set to accept.
To inject the advertised network, use the default, null. Use this
parameter to insert an aggregate or default network along with
the actual network.
(continued)
Comentarios a estos manuales