Avaya Configuring Frame Relay Services Manual de usuario descargar pdf (Pagina 120)

Configuring Frame Relay Services

3-50

117376-C Rev. 00

Editing Signaling Attributes or Parameters for SVCs

A DTE and the frame relay network exchange various type of signaling messages,

including incoming and outgoing call setup, call proceeding, connect and

disconnect, and release messages. You can use either the BCC or Site Manager to

customize signaling attributes or parameters.

Using the BCC

To edit signaling attributes:

State

State controls whether signaling is enabled or disabled. To change this value:

Navigate to the signaling prompt.

For example:

box; serial/1/2; frame-relay/1/2; signalling/1/2

Enter the

state

command and the value you want to use.

state

<value>

Legal values are

enabled

and

disabled

. The default value is

enabled

For example, the following command line disables signaling.

signalling/3/2# state disabled

signalling/3/2#

Maximum SVCs

Maximum SVCs indicates the maximum number of simultaneous switched virtual

circuits allowed on the port. The more SVCs you allow, the larger the system

memory required to support them. To set the window size:

Navigate to the signaling prompt.

For example:

box; serial/1/2; frame-relay/1/2; signalling/1/2

Enter the

maximum-svcs

command and the value you want to use.

maximum-svcs

is the number of SVCs allowed. Legal values are 1 to 2147483647.

The default is 100.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 239 240

Sin comentarios

Avaya Configuring Frame Relay Services Manual de usuario Pagina 120