Avaya Configuring Frame Relay Services Manual de usuario descargar pdf (Pagina 116)

Configuring Frame Relay Services

3-46

117376-C Rev. 00

Enter the

station-type

command and one of the following options:

dce

dte

networkside

(which means DCE)

userside (which means DTE)

For example, the following command line sets station type DCE:

lapf/3/2# station-type dce

lapf/3/2#

Initiation Mode

Initiation mode determines the action LAPF will take to initiate link setup by

sending or holding unnumbered command (SABME) frames to poll the router at

the other end of the connection. To set the initiation mode:

Navigate to the LAPF prompt.

For example:

box; serial/1/2; frame-relay/1/2; lapf/1/2

Enter the

initiation-mode

command and either

active

(the default) or

passive

Active indicates that LAPF will send SABME frames and initiate link setup.

Passive indicates that LAPF takes no action to initiate link setup. The default

is active.

For example, the following command line sets an initiation mode of passive:

lapf/3/2# initiation-mode passive

lapf/3/2#

Retransmission Timer

Retransmission timer is the general purpose retransmission timeout. It is used

during initiation of LAPF multiple frame support, and for timeout of LAPF

numbered information frames. In the event of a timeout, the sending platform

retransmits the frame, up to the maximum number of times you specify for

retransmission limit. To set the retransmission timer:

Navigate to the LAPF prompt.

For example:

box; serial/1/2; frame-relay/1/2; lapf/1/2

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 239 240

Sin comentarios

Avaya Configuring Frame Relay Services Manual de usuario Pagina 116