
Customizing Frame Relay
117376-C Rev. 00
3-39
SVC Call Block Direction
The
svc-call-block-direction
command enables you to block certain type of calls
on the SVC. Legal values are:
both
none
inbound
outbound
all
To set SVC call block direction:
1.
Navigate to the service prompt.
For example:
box; serial/1/2; frame-relay/1/2; service/8.0.32
2.
Enter the
svc-call-block-direction
command, and one of these options:
For example, the following command line sets a call block direction of
outbound:
service/8.0.32# svc-call-block-direction outbound
service/8.0.32
SVC Screening
The
svc-screen-control
command enables you screen incoming calls on this
service record. Legal values are enabled and disabled. The default is disabled.
To set SVC screen usage:
1.
Navigate to the service prompt.
For example:
box; serial/1/2; frame-relay/1/2; service/8.0.32
2.
Enter the
svc-screen-control
command, and set it to
enabled
.
For example, the following command line enables call screening:
service/8.0.32# svc-screen-control enabled
service/8.0.32
Comentarios a estos manuales