Avaya Configuring BOOTP Services Manual de usuario Pagina 25

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 196
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 24
Starting SNMP, BootP, and DHCP Services
308644-15.1 Rev 00
1-5
Starting SNMP Services
You can use the BCC command-line interface or the Site Manager graphical user
interface to start SNMP on the router, accepting default values for all parameters.
SNMP is globally enabled on the router by default when you install BayRS
software. By default, the Quick-Start installation script (install.bat) creates a
read/write SNMP community named public with a wildcard manager (0.0.0.0)
that allows universal read/write access. You should restrict read-write access to the
router as soon as possible by reconfiguring the security of this SNMP community.
When you add SNMP with the BCC, access is defined by default as read-only.
If you decide to change some or all of the default values, refer to the instructions
in Chapter 3
, Customizing SNMP.
Before you begin, verify that IP is configured on an interface, as described in
Configuring IP for Global Protocols
on page 1-2.
Using the BCC
To configure SNMP on the router with default settings, begin in configuration
mode at the box or stack prompt:
1.
Configure SNMP.
box#
snmp
2.
Display SNMP default settings.
snmp#
info
lock enabled
lock-address 0.0.0.0
lock-timeout 2
authentication-traps enabled
type-of-service reliability
state enabled
Vista de pagina 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 195 196

Comentarios a estos manuales

Sin comentarios