Avaya Configuring BOOTP Services Manual de usuario descargar pdf (Pagina 102)

Configuring SNMP, BootP, and DHCP Services

4-2

308644-15.1 Rev 00

Customizing BootP Relay Agent Parameters

After you configure IP interfaces for BootP services, you can configure BootP

relay agent parameters for all of these IP interfaces. The BootP relay agent is

responsible for transmitting BOOTREQUEST packets to servers on the network

and for transmitting BOOTREPLY packets to clients.

Disabling and Reenabling BootP

When you start BootP on an interface, BootP is automatically enabled on that

interface and default values are in effect for all BootP parameters.

You can use the BCC or Site Manager to disable or reenable BootP on an

interface.

Using the BCC

To disable BootP on an IP interface, go to the BootP interface prompt (for

example,

box; eth 2/2; ip/2.2.2.2/255.255.0.0; bootp

) and enter:

state disabled

For example, the following command line disables BootP services on IP interface

2.2.2.2.

bootp/2.2.2.2#

state disabled

To reenable BootP on an IP interface, go to the BootP interface prompt and enter:

state enabled

For example, this command line reenables BootP services on IP interface 2.2.2.2.

bootp/2.2.2.2#

state enabled

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 195 196

Sin comentarios

Avaya Configuring BOOTP Services Manual de usuario Pagina 102