Avaya Configuring BOOTP Services Manual de usuario descargar pdf (Pagina 126)

Configuring SNMP, BootP, and DHCP Services

4-26

308644-15.1 Rev 00

Specifying the Pass Through Mode for Packet Forwarding

You can allow the BootP relay agent to transmit BootP packets, DHCP packets, or

both to a preferred server by specifying the pass through mode. The default setting

is BootP, which allows the BootP relay agent to transmit only BootP packets to the

preferred server you designate.

You can use the BCC or Site Manager to set the pass through mode for the

preferred server.

Using the BCC

To set the pass through mode for a preferred server, go to the preferred-server

interface prompt (for example,

box; eth 2/2; ip/2.2.2.2/255.255.0.0; bootp;

preferred-server

) and enter:

pass-thru-mode

<value>

value

is one of the following:

bootp

(default)

bootp-dhcp

dhcp

For example, this command line sets the pass through mode to bootp-dhcp, which

causes the BootP relay agent to broadcast both BootP and DHCP packets to the

preferred server 4.4.4.4 configured on IP interface 2.2.2.2.

preferred-server/2.2.2.2/4.4.4.4#

pass-thru-mode bootp_dhcp

preferred-server/2.2.2.2/4.4.4.4#

Note:

Make sure that the pass through mode you set for all preferred servers is

consistent with the mode you set for the BootP interface. If these settings are

inconsistent, the router drops packets. For example, if you set the pass through

mode for the BootP interface to bootp, you must set the mode for all preferred

servers to bootp or to bootp_dhcp.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 195 196

Sin comentarios

Avaya Configuring BOOTP Services Manual de usuario Pagina 126