Avaya Configuring BOOTP Services Manual de usuario descargar pdf (Pagina 174)

Configuring SNMP, BootP, and DHCP Services

A-22

308644-15.1 Rev 00

BootP Preferred Server Configuration Parameters

Use the following guidelines to configure BootP and DHCP preferred server

configuration parameters.

Parameter: DLCI Number

Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface

Table > Client I/F > Add

Default: None

Options: 16 to 1007

Function: Specifies the frame relay PVC identification number whose destination is the

remote AN that will boot using EZ-Install. The frame relay network uses the

DLCI number to direct data flow.

Instructions: Enter the DLCI number, in decimal format, for the group access PVC to the

remote AN. Use the DLCI number assigned by your frame relay service

provider.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.1.1.1.2

Parameter: Relay Agent IP Address

Path: Configuration Manager > Protocols > IP > BOOTP > Relay Agent Interface

Table > Pref Serv > Add

Default: None

Options: Any valid IP address

Function: Specifies the IP interface that receives BOOTREQUEST or DHCP packets from

clients.

Instructions: Enter the IP address of a numbered network interface that you want to receive

BOOTREQUEST or DHCP packets from clients, and then configure this IP

address on the router, if you have not already done so.

Do not specify an unnumbered interface for this parameter.

MIB Object ID: 1.3.6.1.4.1.18.3.5.3.8.3.3.1.3

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 195 196

Sin comentarios

Avaya Configuring BOOTP Services Manual de usuario Pagina 174