
Customizing BootP/DHCP Relay
308644-15.1 Rev 00
5-3
Using Site Manager
To allow the BootP relay agent to forward DHCP packets, complete the following
tasks:
Defining DHCP Servers
If DHCP clients obtain IP addresses and other configuration information from a
DHCP server on a different subnet, connected through a router, then you must
define a DHCP preferred server by specifying the IP address of the BootP relay
agent on the local router and the IP address of the target server. The router can
then unicast a DHCP packet through normal IP services to that server. For
instructions, see “Specifying Servers for BootP Services
” on page 4-21.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
BOOTP
. The BOOTP menu opens.
4. Choose
Relay Agent Interface Table
. The BOOTP Relay Agent Interface Table
window opens. This window lists all the IP
interfaces that you configured for BootP
services on the router.
5. Click on
Forward I/F
. The BOOTP Relay Agent Forwarding
Table window opens.
6. Select the address pair that you want to
configure.
7. Set the
Pass Through Mode
parameter.
Click on
Help
or see the parameter
description on page A-21.
8. Click on
Apply
.
9. Click on
Done
. You return to the Configuration Manager
window.
Comentarios a estos manuales