
Configuring TMS and Security for erpcd Networks
303509-A Rev 00 5-7
ha
=<
ha_addr>
Not used in Dial VPN. Supported only
for compatibility with previous versions.
Specifies the IP address of the frame
relay port on the gateway in which the
home agent (ha) resides. The address
0.0.0.0 is not valid.
For compatibility with
previous versions, Dial
VPN recognizes this
parameter as equivalent
to tunnel end point (te),
but it is no longer a valid
syntactical element.
maxu
=[<
max_users>
|
unlimited
] Specifies the maximum number of
concurrent users allowed on the system.
A value of unlimited means that any
number of concurrent users is allowed.
A value of 0 indicates that no users are
allowed on the system.
For the
modify
command, you can use
this value to disable a domain without
deleting it. If you reset the
maxu
parameter to a value below the current
number of users, additional (new) users
must wait until the count drops below the
new maximum. Excess users, however,
are not arbitrarily dropped.
Required for
add
and
modify
. Not used for
other commands.
(continued)
Table 5-2. tms_dbm Command Arguments
(continued)
Argument Function
Used with These
Commands
Comentarios a estos manuales