Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Manual de usuario Pagina 133

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 190
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 132
Planning Worksheet
303509-A Rev 00 A-3
If this is a RADIUS-only configuration, list the IP address of the RADIUS
TMS server.
(name) __________________________________________________
(IP address) ____________________________________________
If this configuration uses the Dynamic Host Configuration Protocol
(DHCP), list the IP address(es) of the DHCP servers.
(IP address) ____________________________________________
(IP address) ____________________________________________
What type of Routing Information Protocol (RIP) update packets will
your network advertise/accept? (OSPF is not supported.)
___ Only RIP 1 ___ Only RIP 2 ___ Both RIP 1 and RIP 2
For Each Destination Site
Record information about each site with which the remote users want to connect.
Site Name: ____________________________________
For the CPE router with which the gateway connects:
-- What is its IP address?__________________________________________
-- What is its subnet mask? ________________________________________
-- What is its DLCI (frame relay only)? ______________________________
If the CPE router is a Bay Networks (or other non-Cisco) router, you
must configure an adjacent host on the CPE router. Fill in the following
information about the adjacent host.
--What is the IP address of the adjacent host (that is, the next-hop router,
in this case, the gateway port)? ___________________________________
-- What is the IP address of the CPE router’s network interface to the
adjacent host? ________________________________________________
-- What is the subnet mask of the adjacent host?
____________________________________________________________
-- What is the physical media access control (MAC) address of the adjacent
host (for frame relay, its DLCI number)?
__________________________________________
For the static route between the CPE router and the RADIUS client on
the gateway:
-- What is the IP address of the RADIUS client to which you want to
configure the static route?_______________________________________
-- What is its subnet mask? ________________________________________
Vista de pagina 132
1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 189 190

Comentarios a estos manuales

Sin comentarios