
Requirements Outside the ISP Network
303509-A Rev 00 8-9
• Use the Site Manager Statistics Manager to verify that the frame relay
connection is operational. Select Site Manager > Tools > Statistics Manager >
Launch Facility > FR_VC_DAT to view the frame relay Virtual Circuit Table.
This table displays any configured DLCIs and a control DLCI. If frames are
moving over a configured circuit, the status of its DLCI is Active.
Configuring PPP on the CPE Router
If the CPE router is a Bay Networks platform, see Configuring PPP Services for
details on configuring PPP on an interface. Otherwise, refer to the PPP
documentation appropriate to the CPE router on the home network for detailed
PPP configuration information.
The rest of this section describes the most important Dial VPN considerations for
configuring the PPP parameters.
• If you are using Site Manager, you can accept the default values for most PPP
parameters.
• You must configure two static routes from the CPE router: one to the
RADIUS client on the gateway and one to the remote node’s supernet that
services all the remote nodes in the same user community. In addition, for Bay
Networks routers, you must configure an adjacent host as the next hop for the
return messages.
• Ensure that a PPP circuit is configured between the gateway and the CPE.
• Use the Site Manager Statistics Manager to verify that the PPP connection is
operational.
Note:
You cannot use the
ping
command to test the connection between the
CPE and the RADIUS client on the gateway because there is no path back to
the CPE.
Note:
You cannot use the
ping
command to test the connection between the
CPE and the RADIUS client on the gateway because there is no path back to
the CPE.
Comentarios a estos manuales