Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Manual de usuario Pagina 71

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 190
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 70
Configuring the Remote Access Concentrator
303509-A Rev 00 4-3
set port ppp_ncp all
(<---This could be set to ipcp and ipxcp.)
The
slip_ppp_security
parameter controls dial-in PPP access and use of ACP
or RADIUS for PPP and protocol security. The
ppp_sec_protocol
parameter
specifies the local authentication protocol; in this case, CHAP. A client dialing
in has to get a remote IP address. For Dial VPN, the
address_origin
parameter
must be set to
auth_server
. For information on BSAC security, refer to the
BaySecure Access Control Administration Guide.
The annex
show port ppp
command shows several configuration parameters
on one screen. Make sure that the
ppp_ncp
parameter is set to all or IPCP and
IPXCP.
For information on the settings of the remaining port parameters, refer to
Managing Remote Access Concentrators Using Command Line Interfaces.
Set the primary preferred security host to the address of the primary TMS
server. You can also designate the secondary TMS server (if any) as the
secondary preferred security host. Accept the default value if the optional
secondary security host is not in use.
Enable security on the RAC, but disable the security broadcast feature. Setting
the security broadcast parameter to N ensures that the security information
comes from one of the defined TMS servers.
For the Remote Access Concentrator Model 8000/5399, enter the following
configuration command sequence from the
na
or
admin
prompt:
set annex enable_security y
set annex pref_secure1_host
#
<ip_address_of_TMS/security host---acp_or_BSAC>
#
set annex pref_secure2_host
#
<ip_address_of_secondary_TMS_security_host>
#
set annex security_broadcast N
set annex auth_protocol
<acp_or_RADIUS>
#
set port mode auto_detect
set port type dial_in
set port slip_ppp_security y
set port ppp_security_protocol chap
# This could be chap, pap, or pap-chap.
Vista de pagina 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 189 190

Comentarios a estos manuales

Sin comentarios