
Configuring and Troubleshooting Bay Dial VPN Services
4-4 303509-A Rev 00
4.
Enable the appropriate options.
To display the options that are enabled, use the CLI
stats -o
command.
For a PRI connection on a Remote Access Concentrator, create Session
Parameter Blocks in the config file, as shown in the following example.
Configuring the "%wan" section of the config file this way lets any user dial in
to the device. (By default, the path to the config file is
/usr/spool/erpcd/bfs/config.annex.)
The following sample session parameter blocks (SPBs) set configuration
parameters for sessions (calls) based on dialed number, calling number, and
call type. Each incoming call is compared against each SPB, in order, until
there is a match. If no match exists, the RAC rejects the call.
%wan
#
# The following SPB causes the RAC to answer all “voice” bearer calls
# with a modem.
#
begin_session modem
bearer voice
call_action modem
set mode auto_detect
end_session
# The following SPBs are possible templates for handling V.120 and
# sync PPP calls. To enable these SPBs, edit the “called_no.” line
# in each to include the telephone numbers specific to your PRI line.
# Use different numbers for each service (that is, V.120 or sync). You
# must also remove the comment (#) characters at the start of each line.
#
# It is not always necessary to discriminate calls based on called
# number. If all data calls will be V.120, for example, and never sync PPP,
# such a distinction is unnecessary.
#
Note:
Dial VPN works only for native PPP (you cannot dial in as CLI, then
convert to PPP to use Dial VPN).
Comentarios a estos manuales