Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Manual de usuario Pagina 124

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 190
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 123
Configuring and Troubleshooting Bay Dial VPN Services
8-18 303509-A Rev 00
Configuring IPX on the Home Network RADIUS Server
BaySecure Access Control (BSAC) is the RADIUS server that resides on the CPE
network and communicates with the RADIUS client on the gateway router. This
example uses the UNIX-based version of BSAC, but the same principles apply to
configuring BSAC for other platforms.
To add IPX protocol support on the BSAC (or any other) RADIUS server, you
must set the
Framed-IPX-Network
parameter to the appropriate value, ensuring
that the value is in the appropriate format (that is, hexadecimal or decimal).
The RADIUS server passes the Novell network number to the dial-in user. That
number must correspond to the CPE router’s S11 frame relay access WAN link’s
Novell network number, so that no static routes are required. The router knows the
correct frame relay DLCI associated with that Novell network number, because it
is the router’s synchronous interface.
Configuring DHCP Dynamic Address Assignment (Layer 3)
To use DHCP for dynamic address assignment, you must have a DHCP server on
the customer’s home network configured to dynamically assign IP addresses from
a designated range of addresses. This server communicates with a DHCP client
proxy on the Layer 3 gateway. The server dynamically allocates an IP address for
a dial-in user when the client proxy requests one.
Chapter 5 describes configuring the TMS parameters necessary for DHCP. The
following sections describe how to define assignable address ranges.
Defining Assignable DHCP Address Ranges
The following sections pertain to configuring DHCP address ranges using the
Microsoft Windows NT DHCP Manager tool. Scope is a Microsoft term for an
address range. The principles apply for both Windows NT and UNIX systems, but
the tool applies only to Windows NT. You can use any DHCP server that can
Note:
To determine the value for the
ipx_frame_type
parameter at the Novell
server, you can examine the AUTOEXEC.NCF file or issue the Novell console
command
protocol
. The Novell command
loadinstall
lets you set all of the
options.
Vista de pagina 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 189 190

Comentarios a estos manuales

Sin comentarios