Avaya Configuring and Troubleshooting Bay Dial VPN (DVS) Networks Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 190
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
Dial VPN Layer 2 Tunneling
303509-A Rev 00 2-3
2.
Install and configure any intermediate nodes on the WAN.
The WAN can include intermediate nodes. For installation and startup
information, refer to the hardware documentation for each device.
3.
Install the software for the tunnel management server, Remote Access
Concentrator, and (for the
erpcd
-based solution) Access Control Protocol
on the host that serves as the load host for the Remote Access
Concentrator.
For installation instructions, see the Remote Access Concentrator
documentation.
4.
Load the operating software onto the Remote Access Concentrator and
boot the Remote Access Concentrator.
For detailed descriptions of the boot procedures, see the Remote Access
Concentrator documentation.
5.
Configure the Remote Access Concentrator software, as described in
Chapter 4, to handle PPP dial-in calls from remote nodes, determine
whether they are tunnel clients, and route them appropriately.
6.
Configure the TMS (including the authentication type) by adding an
entry in the TMS for each domain in the TMS database. See Chapter 5
and Chapter 6 for more information.
When configuring the TMS, you can choose either local or remote
authentication. Dial VPN uses a RADIUS server on the customer’s home
network to provide authentication and assign IP addresses.
For DHCP address allocation, configure the TMS with the DHCP parameters,
as described in Chapter 5.
7.
Establish a connection between the edge router on the Dial VPN network
and a CPE router (the LNS) on the home network using frame relay or
PPP.
8.
Make sure that the home network is configured to connect to the Dial
VPN network.
Specifically, ensure that:
The RADIUS server on the home network is configured to work with the
RADIUS client on the Dial VPN network. If dynamic IP address
allocation or DHCP is enabled, the RADIUS or DHCP server must have
an allocated pool of addresses for authenticated dial-in users and have
RADIUS accounting enabled.
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 189 190

Comentarios a estos manuales

Sin comentarios