
Configuring and Troubleshooting Bay Dial VPN Services
4-8 303509-A Rev 00
Configuring the RAC to Advertise RIP 1 and/or RIP 2 Updates
By default, active RIP sends RIP Version 2 updates to the IP broadcast address, so
that both RIP 1 and RIP 2 systems can receive them. This assumes that
rip_send_version
is set to compatibility, which is the default. It also assumes that
the routers on your network accept both RIP 1 and RIP 2 updates. Although
discarding RIP 2 updates violates the RIP 1 RFC (RFC 1058), some RIP
implementations written before this RFC still do so. If you have both RIP 1 and
RIP 2 nodes on your network, make sure that there are no RIP 1 implementations
that discard RIP 2 packets. If there are, use the
na or admin mode to set the
rip_send_version
parameter to 1, as shown in the following example:
annex:
su
password:
annex#
admin
RAC administration Remote RAC R15.0
admin:
set interface=all rip_send_version 1
You may need to reset the appropriate port or RAC subsystem, or reboot the RAC
for changes to take effect:
admin:
quit
annex#
boot
The
boot
command is required in the preceding example because you are setting
en0. If en0 is not among the interfaces, you can substitute the admin command
reset interface
for the
boot
command.
Comentarios a estos manuales