
Requirements Outside the ISP Network
303509-A Rev 00 8-7
• The IP address of the CPE router’s network interface to the adjacent host (next
hop)
• The subnet mask of the IP address specified as the adjacent host
• For frame relay, the physical address of the adjacent host (DLCI number)
• The adjacent host’s encapsulation method (in this case, Ethernet)
Configuring a Static Route Between the CPE and the Gateway
If you use Site Manager to configure a static route on the CPE router at the user’s
home network, Bay Networks suggests that you accept the default parameter
values where possible. The Site Manager path to these parameters is
Configuration Manager > Protocols > IP > Static Routes.
When you configure static routes, you must specify:
• Static routing enabled (default).
• The IP address of the Dial VPN gateway router to which you want to
configure the static route -- that is, the home agent’s IP address (required).
• The subnet mask of the Dial VPN network gateway. This can be any subnet
mask that is valid with the network class of the destination IP address
(required).
• The number of router hops a packet can traverse before reaching the Dial
VPN gateway (default is 1).
• The IP address of the next-hop router (the adjacent host) in the packet’s path
between the CPE router and the Dial VPN gateway (required).
• The subnet mask of the next-hop router (required).
• A weighted value (with 16 being the most preferred) that the IP router uses to
select a route when its routing tables contain multiple routes to the same
destination (default is 16).
• The name of the circuit on the local router associated with the static route over
an unnumbered interface (required only for unnumbered interfaces).
Comentarios a estos manuales