
Configuration Examples
308621-14.00 Rev 00
B-41
Outgoing Phone List Configuration
From the Primary Circuit Definition window, configure the outgoing phone list for
each router by completing the following tasks:
The ISDN Numbering Plan and ISDN Numbering Type parameters default to the
correct values based on the switch type you configured. Do not change these
parameters unless you receive explicit instructions from your service provider.
Caller Resolution Table Configuration
Router 1, the master router, does not require a caller resolution table. Router 1
initiates calls to router 2, it does not receive them; therefore, router 1 does not
need to verify router 2’s identity. In contrast, router 1 must have a CHAP name
and secret that it places in the call setup message to identify itself to router 2.
Router 2, the slave router, requires a caller resolution table entry. Router 2 receives
calls from router 1 and must identify the incoming caller. After configuring the
backup circuits, you must configure the caller resolution table on router 2.
Site Manager Procedure
You do this System responds
1. In the Primary Circuit Definition window,
select a circuit.
2. Click on
Phone Out
. The Outgoing Phone List window opens.
3. Click on
Add.
The Phone Number window opens.
4. Set the
Outgoing Phone Number
parameter as follows:
•
Router 1:
4363333
• Router 2:
4364444
Do not use hyphens or other nonnumeric
characters.
5. Click on
OK
. You return to the Outgoing Phone List
window.
6. Click on
Done
. You return to the Primary Circuit
Definition window.
7. Click on
Done
. You return to the Configuration Manager
window.
Comentarios a estos manuales