Avaya Configuring Dial Services Manual de usuario Pagina 104

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 552
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 103
Configuring Dial Services
3-14
308621-14.00 Rev 00
Configuring PRI Lines
PRI lines are available only on the ASN, BCN, and BLN platforms using the
following link modules:
Single or Dual Port Multichannel T1 Link Module (BLN and BCN)
Dual Port Multichannel T1 Net Module (ASN)
120-ohm Single Port MCE1-II Link Module (BLN and BCN)
120-ohm Single or Dual Port MCE1-II Net Module (ASN)
QMCT1 Link Module (BLN and BCN)
To configure PRI lines, create the physical interface for the backup PRI interface
by entering:
mct1
<
slot/module/connector
>;
pri
or
mce1
<
slot/module/connector
>;
pri
module
is only required for the ASN router.
For example:
box#
mct1 3/1; pri
For more information about MCT1 and MCE1 parameters, see Configuring WAN
Line Services.
Go to “Designating an Interface
As a Dial Object” on page 3-14.
Designating an Interface As a Dial Object
Designating an interface as a dial object tells the router that it can use the interface
as a dial line in a line pool.
For dial backup lines, the
dial
command also configures the default layer 2
protocol, PPP.
Vista de pagina 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 551 552

Comentarios a estos manuales

Sin comentarios