
Configuring and Customizing IGMP
117355-C Rev 00
3-23
Configuring an IGMP Boundary Group
You configure an IGMP boundary group by supplying a range of multicast group
addresses (expressed as an address and a prefix) and a list of IP interfaces. No
multicast group address that falls within the range you specify is accepted or
forwarded on the interfaces you specify.
You can use Site Manager to define an IGMP boundary group.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
IGMP/IGMP Relay
. The IGMP menu opens.
4. Choose
Admin Scope
. The IP IGMP Admin Scope window
opens.
5. Click on
Add
. The IGMP Admin Scope window opens.
6. Set the following parameters:
• Group Address
• Prefix Length
• Circuit List
• Tunnel List
Click on
Help
or see the parameter
descriptions beginning on page A-63.
7. Click on
OK
. You return to the IP IGMP Admin Scope
window.
8. Click on
Done
. You return to the Configuration Manager
window.
Comentarios a estos manuales