
Site Manager Parameters
117355-C Rev 00
A-63
IGMP Boundary Group Parameters
Use the following descriptions to set IGMP boundary group parameters.
Parameter: Enable
Path: Configuration Manager > Protocols > IP > IGMP/IGMP Relay > Admin Scope
Default: Enabled
Options: Enabled
|
Disabled
Function: Specifies whether this record is enabled or disabled.
Instructions: To disable the boundary group record, enter Disabled.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.13.5.1.2
Parameter: Group Address
Path: Configuration Manager > Protocols > IP > IGMP/IGMP Relay > Admin Scope
Default: None
Options: A valid group address.
Function: Specifies the address of a multicast host group.
Instructions: Enter a group address to define this IGMP boundary record.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.13.5.1.3
Parameter: Prefix Length
Path: Configuration Manager > Protocols > IP > IGMP/IGMP Relay > Admin Scope
Default: None
Options: A valid prefix for the group address.
Function: Specifies a prefix for the multicast host group address.
Instructions: Enter an address prefix to define this IGMP boundary record.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.13.5.1.
Comentarios a estos manuales