
Customizing DVMRP
117355-C Rev 00
4-47
Supplying Addresses for a Tunnel
To identify a unicast tunnel, you must supply the unicast IP address of both ends
of the tunnel: the local interface and the remote interface. You can use the BCC or
Site Manager to supply these addresses.
Using the BCC
Navigate to the box-level prompt and enter:
tunnels
The tunnel prompt appears. Enter the following command:
dvmrp local
<local_ip_address>
remote
<remote_ip_address>
local_ip_address
is the unicast IP address of an interface on the router.
remote_ip_address
is the IP unicast address of an interface on the remote
DVMRP router.
For example, the following command configures a DVMRP unicast tunnel. The
local end point of the tunnel is unicast IP interface 2.2.2.2. The remote end point
of the tunnel is unicast IP interface 2.2.4.5.
box#
tunnels
tunnels#
dvmrp local 2.2.2.2 remote 2.2.4.5
dvmrp/2.2.2.2/2.2.4.5#
Comentarios a estos manuales