
Site Manager Parameters
117355-C Rev 00
A-43
Parameter: Route Preference
Path: Configuration Manager > Protocols > IP > Policy Filters > DVMRP >
Unicast Accept Policies
Default: 0
Options: 0 to 16
Function: Specifies a value that DVMRP uses to compare the route for injection to an
existing route in the DVMRP routing table. This parameter has meaning only
if the action is Accept.
Instructions: If the injected unicast route is preferred, set the preference to a higher
number than the preference value of the existing route. A route learned from
a DVMRP network always has a preference of 1.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.17.1.7
Parameter: Rule Precedence
Path: Configuration Manager > Protocols > IP > Policy Filters > DVMRP >
Unicast Accept Policies
Default: 0
Options: 0 to 2,147,483,647
Function: Specifies a metric that DVMRP uses to compare this policy to other policies
that match the route. (Note that policy match is not a most-specific-route
match. This means that DVMRP uses the precedence value to choose
between multiple matches.)
Instructions: In ranking policies according to precedence, keep in mind that the route with
the highest value is the most preferred route. In case of a tie, the route with
the larger index number wins.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.6.17.1.8
Comentarios a estos manuales