
Customizing DVMRP
117355-C Rev 00
4-57
Listening for a Default Route
By default, DVMRP does not listen for a default route on this tunnel.
You can use the BCC or Site Manager to enable and disable this feature as
required.
Using the BCC
Navigate to a DVMRP tunnel-specific prompt and enter:
default-listen
<state>
state
is one of the following:
enabled
disabled
(default)
For example, the following command configures DVMRP to listen for a default
route on tunnel 2.2.2.2/4.4.3.2:
tunnel/2.2.2.2/4.4.3.2#
default-listen enabled
tunnel/2.2.2.2/4.4.3.2#
Using Site Manager
To listen for a default route:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
DVMRP
. The DVMRP menu opens.
4. Choose
Tunnel
. The DVMRP Tunnel Parameters window
opens.
5. Set the
Route Listen
parameter. Click on
Help
or see the parameter description on
page A-14.
6. Click on
Apply
, and then click on
Done
. You return to the Configuration Manager
window.
Comentarios a estos manuales