Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual de usuario Pagina 76

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 94
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 75
Configuring Ethernet, FDDI, and Token Ring Services
A-6 117344-A Rev. A
Parameter: Connection Policy
Path: Configuration Manager > FDDI Connector > Edit Line > Edit FDDI
Parameters > Expert > SMT Attributes > FDDI SMT Attributes
Default: 0xFF65
Options: 0x0 to 0xFFFF
Function: Specifies the connection policies this line requests at the FDDI station.
The policy descriptor takes the form “rejectX-Y” where X denotes the physical
connection (PC) type of the local port, and Y denotes the PC type of the
neighbor port. X and Y can have the following values:
A -- Indicates that the port is a dual-attachment station or concentrator that
attaches to the primary IN and the secondary OUT when attaching to the dual
FDDI ring
B -- Indicates that the port is a dual-attachment station or concentrator that
attaches to the secondary IN and the primary OUT when attaching to the dual
FDDI ring
S -- Indicates a port in a single-attachment station or concentrator
M -- Indicates a port in a concentrator that serves as a master to a connected
station or concentrator
Instructions: Specify the status word value that represents the connection policies you want
this line to reject. Start with a value of zero for the status word (all bits set to 0).
For each connection policy you want the node to reject, add to the status word
value the number 2 raised to a power specified in Table 3-2 on page 3-10. This
is equivalent to setting a bit to 1 for each policy that you want the node to reject.
MIB Object ID: 1.3.6.1.4.1.18.3.4.4.1.30
Parameter: T_Notify Timeout
Path: Configuration Manager > FDDI Connector > Edit Line > Edit FDDI
Parameters > Expert > SMT Attributes > FDDI SMT Attributes
Default: 22
Options: 2 to 30 seconds
Function: Specifies the interval between successful iterations of the Neighbor Notification
Protocol.
Instructions: Accept the default value of 22 seconds or specify a new value from 2 to 30
seconds.
MIB Object ID: 1.3.6.1.4.1.18.3.4.4.1.31
Vista de pagina 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 93 94

Comentarios a estos manuales

Sin comentarios