
Site Manager Line Services Parameters
117344-A Rev. A A-5
Parameter: Hardware Filter
Path: Configuration Manager > FDDI Connector > Edit Line > Edit FDDI
Parameters
Default: Disable (the default changes to Enable when, while adding the circuit , you
reply OK to the prompt:
Do you want to enable Hardware Filters on this circuit?)
Options: Enable
| Disable
Function: When you set this parameter to Enable, the link module filtering hardware, if
present, does not allow the router to copy local frames into memory. In essence,
the filtering hardware drops local frames at the interface. Hardware filtering
improves performance because the bridging software no longer uses resources
to receive and reject those frames.
Instructions: Set to Enable only if the link module has hardware filters and you enabled
bridge software.
MIB Object ID: 1.3.6.1.4.1.18.3.4.4.1.37
Comentarios a estos manuales