
Configuring Ethernet, FDDI, and Token Ring Services
3-16 117344-A Rev. A
Using Site Manager
Complete the tasks in the following table to enable or disable duplicate addressing
on an interface.
Entering User Data
You can enter up to 32 alphanumeric characters of site-specific information to be
attached to the status information frames (SIFs) on this interface. You can do this
only by using Site Manager.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose a FDDI Connector
.
The Edit Connector window opens.
2. Choose Edit Line. The Edit FDDI Parameters window
opens.
3. Choose Expert. The FDDI Advanced Attributes window
opens.
4. Choose SMT Attributes. The FDDI SMT Attributes window opens.
5. Set the Duplicate Address Protocol
parameter. Click on Help or see the
parameter description on page A-8.
6. Click on OK. Site Manager returns you to the FDDI
Advanced Attributes window.
7. Click on Done. Site Manager returns you to the Edit
Connector window.
8. Click on Done. Site Manager returns you to the
Configuration Manager window.
Comentarios a estos manuales