
Site Manager Line Services Parameters
117344-A Rev. A A-3
FDDI Line Parameters
Parameter: Hardware Filter
Path: Configuration Manager > XCVR Connector (10BASE-T only) > Edit Line >
Edit CSMA/CD Parameters
Default: Disable (the default changes to Enable when, while adding the circuit, you reply
OK to the prompt:
Do you want to enable Hardware Filters on this circuit?)
Options: Enable
| Disable
Function: Enables filtering hardware in the link or net module to drop local frames at the
interface instead of copying them into system memory. Enabling hardware
filters improves bridging software performance because router resources are not
used to receive and reject local frames.
Instructions: Set to Enable only if you enabled the bridge software and the link or net module
has hardware filters.
MIB Object ID: 1.3.6.1.4.1.18.3.4.1.1.29
Parameter: Enable
Path: Configuration Manager > FDDI Connector > Edit Line > Edit FDDI
Parameters
Default: Enable
Options: Enable
| Disable
Function: Enables or disables the FDDI circuit for the selected connector.
Instructions: Set to Enable or Disable.
MIB Object ID: 1.3.6.1.4.1.18.3.4.4.1.2
Comentarios a estos manuales