Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual de usuario descargar pdf (Pagina 67)

Configuring Token Ring Services

117344-A Rev. A 4-5

Using Site Manager

Complete the tasks in the following table to set the source for MAC addresses.

Specifying the Ring Speed

You can set the ring speed for a token ring interface to 4 or 16 Mb/s. By default,

the ring speed is 16 Mb/s.

If you use 16 Mb/s, the router enables the early token release protocol, which is

used extensively on 16 Mb/s media. In the unlikely event that you want to disable

early token release over 16 Mb/s token ring media, disable early token release as

described in the next section.

Using the BCC

To set the ring speed for a token ring interface, access an existing token ring line

service and enter:

speed

<value>

is either 4 Mb or 16 Mb.

For example, to set the ring speed to 16 Mb:

box> tokenring slot 9 connector 1

fddi/11/1> speed 16

Site Manager Procedure

You do this System responds

1. In the Conﬁguration Manager window,

choose a TOKEN Connector.

The Edit Connector window opens.

2. Choose Edit Line. The Edit Token Ring Parameters window

opens.

3. Set the MAC Address Select parameter.

Click on Help or see the parameter

description on page A-12.

4. Click on OK. Site Manager returns you to the Edit

Connector window.

5. Click on Done. Site Manager returns you to the

Conﬁguration Manager window.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 93 94

Sin comentarios

Avaya Configuring Ethernet, FDDI, and Token Ring Services Manual de usuario Pagina 67