Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario descargar pdf (Pagina 44)

Connecting BayStack AN and ANH Systems to a Network

2-6

Completing a Startup Option

This section lists the steps required to complete

• EZ-Install

• Netboot

• Directed Netboot

• Local Boot

You can use Netboot for some procedures and Local Boot for others, provided you

set up the network to support Netboot.

EZ-Install

Completing the EZ-Install option requires the following steps:

1. You use the Conﬁguration Manager in local mode to create a complete

conﬁguration ﬁle for the AN/ANH. (See Cha

pter 4 and Conﬁguring Routers.)

2. You set up a UNIX workstation on the network to support BOOTP.

(See Cha

pter 3.)

3. You create a BOOTP relay interface table on the upstream router to support

automated addressing, and conﬁgure all routers between the BOOTP server

and the booting router as BOOTP relay agents. (See Cha

pter 3.)

4. You ensure that there is a network connection from a synchronous interface

on the AN/ANH to the upstream router.

5. A person at the AN/ANH site installs and boots the router. (See the hardware

Installing and Starting guide for the AN or ANH.)

Note: To boot an AN/ANH over the network, all other routers in the path to

the BOOTP server must be running Router Software Version 7.60 or higher.

Note: If the AN/ANH will connect to the upstream router using a Frame Relay

circuit, be sure the upstream router is running Router Software Version 7.80 or

higher.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 167 168

Sin comentarios

Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario Pagina 44