Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario descargar pdf (Pagina 100)

Connecting BayStack AN and ANH Systems to a Network

6-10

HostTopN Group

The HostTopN group ranks hosts according to a statistic type. For example, you

might want to rank the hosts by the number of errors they generate. Control

parameters for this group appear in the hostTopNControlTable, and data this

group generates appears in the hostTopNTable. To use the HostTopN group, you

must set up the Host group.

Matrix Group

The Matrix group stores statistics for an interchange between interfaces at

different addresses. This group’s control parameters, such as the interface that

starts the interchange, appear in the matrixControlTable. When the Matrix group

receives information from a good packet, it places data in both the matrixSDTable

and the matrixDSTable.

Filter Group

The Filter group speciﬁes what type of packets the DCM should capture. Filter

control parameters, such as the minimum length of the packets to capture, appear

in the ﬁlterTable. Associated with each ﬁlter is a channel (a speciﬁc path along

which data ﬂows). Control parameters in the channelTable deﬁne how and where

the ﬁltered packets ﬂow.

Packet Capture Group

The Packet Capture group enables the capture of packets that satisfy the Filter

group control parameters. For example, you can specify the maximum number of

octets from each packet that the group should store in the captureBufferTable. To

use the Packet Capture group, you must set up the Filter group.

For More Information about RMON

The following documents provide more detail:

• RMON MIB (RFC 1757)

• The user guide for Optivity Design and Analysis network management

software

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 167 168

Sin comentarios

Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario Pagina 100