
Connecting BayStack AN and ANH Systems to a Network
1-16
To run the Quick-Start script, you must establish an IP network interface between
the AN/ANH and a Site Manager management workstation (F
igure 1-6). To make
this connection, you use a Technician Interface command.
Figure 1-6. Establishing an IP Network Interface
Configuring the Initial IP Interface
Appendix B briefly describes the Quick-Start procedure, provides worksheets for
preparing to run the procedure for an AN/ANH, and explains how to begin the
Quick-Start script.
Corporate IP network
IP address = 192.32.10.12
Site Manager
workstation
ASCII console or PC
AN or ANH router
Console port
IP address = 192.32.156.7
Subnet mask = 255.255.255.0
Ethernet port
Comentarios a estos manuales