Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario descargar pdf (Pagina 124)

Connecting BayStack AN and ANH Systems to a Network

A-4

Make sure that you enter the proper command at the router console to

conﬁgure the AN/ANH’s initial IP interface.

Refer to “Conﬁguring the Netboot Interface” in Cha

pter 5 if you need

instructions.

3. Make sure that the AN/ANH’s synchronous port conﬁgured for

EZ-Install is cabled to the upstream router, or that the port conﬁgured

for Netboot (synchronous or Ethernet) is cabled properly.

Router Not Sending BOOTP Responses

If a router is receiving BOOTP request messages but failing to return BOOTP

responses, do the following:

1. Use Site Manager to make sure the BOOTP relay agent forwarding table

associated with the router shows an IP address that is conﬁgured on the

IP router.

2. Make sure that the input IP address is correct. If the Hops count is lower

than the router’s position in the path, increase it.

Refer to “Cr

eating the BOOTP Client Interface Table” in Chapter 4 if you

need instructions.

3. Use the Conﬁguration Manager to make sure that BOOTP and IP are

enabled on the incoming and outgoing interfaces.

4. Make sure that the link modules and drivers are enabled. Refer to

Conﬁguring Routers if you need instructions.

BOOTP Server Not Sending BOOTP Responses

If the BOOTP server is receiving BOOTP requests but failing to respond to them,

do the following:

1. Follow the instructions in the section “Displaying the BOOTP Server’s IP

Routes” later in this appendix.

2. Follow the instructions in the section “Debugging the BOOTP Server”

later in this appendix.

3. Make sure that the /etc/inetd.conf ﬁle contains no more than one bootps

entry.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 167 168

Sin comentarios

Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario Pagina 124