Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario descargar pdf (Pagina 40)

Connecting BayStack AN and ANH Systems to a Network

2-2

After you select the initial startup conﬁguration and set up the network (as

described in this guide), you instruct the person at the router site to begin the

appropriate startup option.

EZ-Install

You can use EZ-Install for the initial startup if

• There is a communications link between the AN/ANH and an upstream router

over an HDLC or Frame Relay interface.

• A directory on a BOOTP server contains a customized conﬁguration ﬁle for

the AN/ANH.

EZ-Install is the default option for a new router. It is the easiest option for the

person at the AN/ANH site to perform, because the network automatically

supplies the IP address and conﬁguration ﬁle.

Netboot

You can use Netboot if

• The AN/ANH has a communications link to an upstream router over an

Ethernet, HDLC, or Frame Relay interface.

• You establish a local console or modem connection with the AN/ANH.

• A directory on a BOOTP server contains the software image ﬁle (krnl_an.exe)

and a network conﬁguration ﬁle customized for the AN/ANH.

• You conﬁgure an IP address for the AN/ANH boot interface.

Netboot takes longer than EZ-Install, but minimizes the cost of line usage and the

saturation of the router’s memory.

Note: As an alternative to another person performing the initial startup at the

remote site, you can perform these tasks using a modem connection.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 167 168

Sin comentarios

Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario Pagina 40