Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario descargar pdf (Pagina 127)

Troubleshooting Network Boot Problems

A-7

Use the set command to correct any settings that are incorrect. For

example, if the router has a Token Ring port and the

wfDrivers.wfTMS380Load.0 setting is not 2147483648, enter the

following command to correct it:

set wfDrivers.wfTMS380Load.0 2147483648;commit

• If the router is Netbooting with a synchronous connector, enter the

following command to display the information about the connector,

where <connector> is the connector number:

get wfSyncEntry.*.1.

Make sure that external clocking is set.

• If the router is Netbooting with an Ethernet connector, enter the following

command to display the information about the connector, where

<connector> is the connector number:

get wfCSMACDEntry.*.1.

Identifying Remote Connectivity Problems

The sections that follow provide guidelines for isolating a router addressing

problem or a Netboot problem. Refer to the appropriate section.

• Displaying Messages from the AN/ANH Console

• Displaying Statistics and Error Messages

• Guidelines for Using Packet Capture

• Guidelines for Using a LAN Protocol Analyzer

Displaying Messages from the AN/ANH Console

If you cannot connect to the AN/ANH using Site Manager, we recommend that

you connect the AN/ANH to a modem or console.

If you cable the AN/ANH to a modem, you can dial in and connect to the

AN/ANH remotely. This setup provides the same capabilities as an on-site

console connection. Modem communications, however, are slower.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 167 168

Sin comentarios

Avaya Connecting BayStack AN and ANH Platforms to a Network Manual de usuario Pagina 127