Avaya Configuring Line Services Manual de usuario Pagina 91

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 301
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 90
Configuring Line Services
4-14 114078 Rev. A
You can set the BofL interval to a value from 1 through 60 seconds on this
interface.
Setting the Maximum Transmission Unit Buffer Size
The default buffer size for the HSSI interface, or Maximum Transmission Unit
(MTU), is 4608 bytes. The MTU determines the largest frame that can travel
across the HSSI interface.
You can specify a MTU of 3 to 4608 bytes on this interface.
Viewing the Configured WAN Protocol
You can view which WAN protocol is enabled on this HSSI circuit:
Standard
PassThru
PPP
SMDS
Frame Relay
Accept this setting; changing it does not reconfigure the interface.
Setting the Transmission Interface
You can select the appropriate MIB for the local management interface (LMI) to
use, providing you enable LMI and configure SMDS or Frame Relay across the
HSSI interface. Select one of the following MIBs, depending on the carrier
services the attached DCE device provides:
DS1, at 1.54 MB/s (specified by RFC 1233)
DS3, at 44.736 MB/s (specified by RFC 1232)
Site Manager: BofL Frequency parameter: page A-29
Site Manager: MTU parameter: page A-30
Site Manager: WAN Protocol parameter: page A-30
Vista de pagina 90
1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 300 301

Comentarios a estos manuales

Sin comentarios