
Site Manager Line Services Parameters
114078 Rev. A A-7
Parameter: Hardware Filter
Path: FDDI Connector > Edit Line > Edit FDDI Parameters
Default: Disable (the default changes to Enable when you add a circuit and reply OK to
the prompt
Do you want to enable Hardware Filters on this
circuit?)
Options: Enable
| Disable
Function: When you set this parameter to Enable, the link module filtering hardware, if
present, does not allow the router to copy local frames into memory. In essence,
the filtering hardware drops local frames at the interface. Hardware filtering
improves performance because the bridging software no longer uses resources
to receive and reject those frames.
Instructions: Set to Enable only if you enabled the bridge and the link module has hardware
filters.
MIB Object ID: 1.3.6.1.4.1.18.3.4.4.1.37
Parameter: User Data
Path: FDDI Connector > Edit Line > Edit FDDI Parameters
Default: None
Options: Any string containing up to 32 alphanumeric characters
Function: Allows you to enter additional information about the router. This information is
attached to the status information frames (SIFs).
Instructions: Enter up to 32 alphanumeric characters.
MIB Object ID: 1.3.6.1.4.1.18.3.4.15.1.3.1.8
Comentarios a estos manuales