
Configuring Line Services
Index-6 114078 Rev. A
N
Neighbor Information frames, 2-11
P
Parameter Management frames, 2-11
power level, T1 transmit, 6-10, A-50
primary ring, 2-7
priority queuing, 8-9, A-78
Q
QMCT1
logical line parameters, A-43
parameters
Accept Perf Measurement CR Addr, A-53
Send Performance Measurement CR Addr,
A-53
testing, 6-24
Quality of Service (QoS), 8-1
R
rate adaptation, line, 6-21, A-40
Request Denied frames, 2-11
S
SAS, 2-8
secondary ring, 2-7
service type, 6-20, A-39
Single Attachment Station, 2-8
SMT. See FDDI SMT
ST2 protocol, 8-1
station management (SMT), 2-10
See also FDDI SMT
Status Information frames, 2-11
Status Report frames, 2-11
Support Source CD, xxviii
Synchronous
configuring for multiline, 7-1
default parameters, B-12
parameters
BofL, 5-13, A-55
BofL Timeout, 5-14, A-56
Burst Count, 5-17, A-59
Cable Type, 5-25, A-68
Clock Source, 5-15, A-57
CRC Size, 5-22, A-64
Enable, A-55
Extended Address, 5-25, A-61
Extended Control (S and I frames), 5-24,
A-61
External Clock Speed, 5-16, A-69
Idle RR Frames, 5-24, A-65
Internal Clock Speed, 5-15, A-58
KG84A Cycle, 5-29, A-65
KG84A Remote Resync Wait, 5-29, A-66
KG84A Sync Loss Interval, 5-29, A-66
KG84A Sync Pulse, 5-30, A-67
Link Idle Timer, 5-24, A-60
Local Address, 5-20, A-62
Minimum Frame Spacing, 5-19, A-62
MTU, 5-14, A-56
Network Link Level, 5-23, A-68
Pass Thru Local Address, 5-21, A-63
Pass Thru Remote Address, 5-21, A-64
Promiscuous, 5-15, A-57
Remote Address, 5-20, A-63
Remote Loopback Detection, 5-26, A-69
Retry Count, 5-24, A-60
Retry Timer, 5-25, A-61
RTS Enable, 5-17, A-59
Service, 5-18, A-60
Signal Mode, 5-17, A-58
Sync B Channel Override, 5-27, A-70
Sync Hold Down Time, 5-26, A-68
Sync Line Coding, 5-23, A-69
Sync Media Type, 5-22, A-65
Sync Polling, 5-22, A-67
Sync Priority, 5-26, A-70
Transmit Window Size, 5-18, A-62
WAN Protocol, 5-21, A-64
Comentarios a estos manuales