
Configuring Line Services
A-66 114078 Rev. A
Parameter: KG84A Sync Loss Interval
Path: COM Connector > Edit Line > Edit Sync Parameters
Default: 50 cycles
Options: 2
| 5 | 10 | 25 | 50 | 100 | 200 | 500
Function: Specifies how many cycles the router should wait after detecting an FCS error to
receive a valid frame before declaring that a loss of synchronization has
occurred.
Instructions: Accept the default or select one of the valid options, and be sure to set the RTS
Enable parameter to Enable.
MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.68
Parameter: KG84A Remote Resync Wait
Path: COM Connector > Edit Line > Edit Sync Parameters
Default: 200 cycles
Options: 2
| 5 | 10 | 25 | 50 | 100 | 200 | 500
Function: Specifies the number of cycles that the router waits for the remote KG84A
device to complete a resynchronization operation, when synchronization is lost
and a remotely initiated resynchronization has been detected. After this number
of cycles, the router software determines that the resynchronization failed and
initiates another resynchronization.
Note that if you press the RESYNC button on the local KG84A device, the
router responds as if it were a remotely initiated resynchronization
Instructions: Use different settings at each end of the point-to-point link to avoid a possible
race condition, and be sure to set the RTS Enable parameter to Enable.
MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.69
Comentarios a estos manuales