Avaya Media Processing Server Series System (Software Release 2.1) Manual de usuario descargar pdf (Pagina 277)

Configuration Procedures and Considerations

# P0602477 Ver: 3.1.11 Page 277

PMGR configuration

As the primary mps numbers will not match the secondary mps numbers, the pmgr on

each primary may need to be configured for both the primary and secondary

component numbers. This is only required when the pools defined on the primary are

setup with specific MPS component numbers (instead of using the wildcard "*"

character). Each of these pools that is setup with a specific MPS component must be

duplicated in the $MPSHOME/common/etc/pmgr.cfg file with the

corresponding secondary component number.

For example a primary (tmsi01) with MPS components mps1 and mps2 could be

configured with the following pools in $MPSHOME/common/etc/pmgr.cfg:

defpool line.out

cfgrsrc line.out,phone.168-192.mps.1

cfgrsrc line.out,phone.121-144.mps.2

defpool fax.1

cfgrsrc fax.1,fax.*.mps.1

defpool fax.2

cfgrsrc fax.2,fax.*.mps.2

When this node (tmsi01) is configured to be part of an N+1 group where its backup

components are mps10 and mps11 then the following pools must be added to the

$MPSHOME/common/etc/pmgr.cfg file of tmsi01 (the primary):

cfgrsrc line.out,phone.168-192.mps.10

cfgrsrc line.out,phone.121-144.mps.11

defpool fax.10

cfgrsrc fax.10,fax.*.mps.10

defpool fax.11

cfgrsrc fax.11,fax.*.mps.11

1 2 ... 272 273 274 275 276 277 278 279 280 281 282 ... 305 306

Sin comentarios

Avaya Media Processing Server Series System (Software Release 2.1) Manual de usuario Pagina 277