
Base System Configuration
# P0602477 Ver: 3.1.11 Page 109
TMS Resource Definition Section
;******************************************************************
;
; T M S R S R C D E F I N I T I O N S E C T I O N
;
;******************************************************************
;
; R S R C C O N F I G U R A T I O N
;
; The following section defines the configurations that may be used
; for a tms in this MPS system. The configuration is referenced by
; the configuration name.
;
; [RSRC_CONFIG]
; CONFIG_NAME = BasicConfig
;
; This section is used to define the resources that should be loaded.
; (players, recorders, asr, fax) for this configuration. This will
; allow additional dtmf,cpd,tgen,r2 resources to be loaded as well
; the ones specified in the proto.cfg files.
;
; This section specifies the configuration definition file (CDF) to use
; and the class name (optional) to assign to the created line resources.
; Count specifies the number of resources requested to be loaded
; configuration. This number will be checked against the number of
; licences available in order to load this system.
;
; If the class name is specified here it will override any class name
; specified in the CDF file.
;
; Parameters specified here will override any parameters specified
; in CDF file.
;
; Mode definition is done at this level. Each set of configuration parameters
; specifies the values to set the paramters to for mode 0. This mode is used as the
; default mode for a resource. When specified here it will override
; the system defaults for the resources created.
;
; There may be more than one of class of resource loaded for this configuration
; and there will be one of these class definitions for each type loaded.
;
; Each section will start with [CLASS]
;
;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;
Comentarios a estos manuales